Differences

This shows you the differences between two versions of the page.

--- flash_prepare_pi_zero_image [2020/02/19 12:55] – wf68spef
+++ flash_prepare_pi_zero_image [2021/07/16 20:21] (current) – wf68spef
@@ Line 1: / Line 1: @@
 Each camera in the plane is driven by a pi zero. There is a prepared image for this usecase, but some planespecific parameters need to be set for each image.
-  * Download image from Gitlab: https://gitlab.com/searchwing/development/searchwing-pi-gen
+  * Follow instructions from https://kidslab.gitbook.io/searchwing/preparing-components/software-setup/setup-companion-computer
-  * Flash image to SD Card (e.g. using Etcher Tool)
-  * Set HostName to a unique name in ''/etc/hostname''  and in ''/etc/hosts'' : e.g. Freddy-cam-l
-  * Set Accesspoint depending on left / right camera in ''/etc/wpa_supplicant/wpa_supplicant.conf'' :
-  cam-r : AP1
-  cam-l : AP2
-<code>
-network={
-        ssid="AP1"
-        psk="AP-Password"
-}
-</code>
-  * Insert image into plane and power up
-  * First bootup the filesystem of image (~2Gb) is enlarged to the SD-Card size (64Gb)
-    * Implemented by creating a ''/data'' partition where the image will be saved
-    * Takes ~3-5Minutes
-    * Afterwards filesystem resize the camera-capture & webserver service is started
-  * You can access each camera via its hostname: ssh searchwing@Freddy-cam-l.local
-  * The recorded images can be checked via webserver in the webbrowser: e.g. http:\\Freddy-cam-l.local
-  * Preflightcheck can be done with the searchwing-pi-manager on the laptop