Differences

This shows you the differences between two versions of the page.

--- searchwing-ardupilot-firmware [2019/10/01 18:15] – [Firmware installation] rc servo setup beckmanf
+++ searchwing-ardupilot-firmware [2019/12/17 09:02] (current) – [Ardupilot Telemetrie / Flight Deck] matt96
@@ Line 10: / Line 10: @@
 === RC and Servo Setup ===
-Ardupilot hast just recently added new way which allows to configure the RC channel and the servo behaviour independently. QGC has not included this yet in the RC calibration procedure. Therefore **you have to check the correct servo behavior for RC and autopilot, e.g. BOTH!!!** It is possible that RC works in the right direction but autopilot steers in the opposite direction. This was the reason for the first Ardupilot flight crash.
+Ardupilot hast just recently added new way which allows to configure the RC channel and the servo behaviour independently. QGC has not included this yet in the RC calibration procedure. Therefore **you have to check the correct servo behavior for RC and autopilot: BOTH!!!** It is possible that RC works in the right direction but autopilot steers in the opposite direction. This was the reason for the first Ardupilot flight crash.
 ==== Mag Sensor Setup ====
@@ Line 45: / Line 45: @@
 Arduplane does not support Flight mode changes, e.g. RTL via a dedicated RC Channel.
-==== LuaPilot ====
+==== LuaPilot (veraltet / durch Flight Deck ersetzt) ====
 In order to send telemetry data to the rc, the parameter 'SERIAL4' has to be changed to 'Frsky SPort'. Despite the note that external hardware is needed, telemetry data can be transmitted using the old cable. Unfortunately LuaPilot cannot be used anymore with ArduPilot as the flight modes are labeled wrong. Therefore LuaPilot has to be replaced with this alternative: [[https://www.rcgroups.com/forums/showatt.php?attachmentid=9914295&d=1490893447|https://www.rcgroups.com/forums/showatt.php?attachmentid=9914295&d=1490893447]] (source: [[https://discuss.ardupilot.org/t/lua-script-for-apm-plane-quadplane/16202/4|https://discuss.ardupilot.org/t/lua-script-for-apm-plane-quadplane/16202/4]])
+==== Ardupilot Telemetrie / Flight Deck ====
+Der Parameter SERIAL4_PROTOCOL muss auf 'FrSky SPort Passthrough (OpenTX)' gesetzt sein. Die selbe Einstellung darf nicht gleichzeitig auf mehreren Serial Ports gesetzt sein, da es sonst zu komplikationen kommt.
+Taranis Einstellungen: {{ :bernd2.zip |}}
+Flight Deck Software: http://www.craftandtheoryllc.com