Differences

This shows you the differences between two versions of the page.

--- searchwing-inner-frame [2020/02/12 13:11] – created beckmanf
+++ searchwing-inner-frame [2020/02/12 14:06] (current) – pla image beckmanf
@@ Line 1: / Line 1: @@
 ===== Inner Frame =====
-{{::sw-frame-with-beams.jpg?600|SearchWing inner frame with beams - without tubes}}
 Author: Friedrich Beckmann
+The following image shows the inner frame with beams, without PVC tubes, pixracerplate and gpsplate.
+{{::sw-frame-with-beams.jpg?600|SearchWing inner frame with beams - without tubes}}
 The inner frame is 3D printed.
@@ Line 17: / Line 19: @@
   * gpsplate
-The 3D Print for the walls is done with Ultimaker 3 with "Normal" default print settings plus 2mm wall width. The plates are printed with "Normal" Settings with the Ultimaker 2+. After the print:
+The 3D Print for the walls is done with Ultimaker 3 with "Normal" default print settings plus 2mm wall width. The plates are printed with "Normal" Settings with the Ultimaker 2+. Both use default PLA material. After the print:
   * Remove the support brim by hand