Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
| searchwing-pi-camera [2020/02/15 17:49] – y-cable again beckmanf | searchwing-pi-camera [2020/02/17 17:35] (current) – j0ge4622 | ||
|---|---|---|---|
| Line 32: | Line 32: | ||
| * Take an 8-inch JST-GH cable and remove the connector at one side. Remove 5mm of the isolation at the other. | * Take an 8-inch JST-GH cable and remove the connector at one side. Remove 5mm of the isolation at the other. | ||
| * Put this cable in the JST-GH connector at the location marked " | * Put this cable in the JST-GH connector at the location marked " | ||
| + | {{ : | ||
| Now the power connections from the PowerModule are left. | Now the power connections from the PowerModule are left. | ||
| - | * Take two 6-inch JST-GH cables and remove one connector. | + | * Take two 6-inch JST-GH cables and remove |
| + | * Crimp the Harwin M20 connector at that side | ||
| + | * Insert the JST-GH Cables in pin 1 and 3 of the JST-GH 4 pin power connector | ||
| + | {{ :: | ||
| + | To mark the cables use colored heating tube. | ||
| + | |||
| + | {{ :: | ||