Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
searchwing-pi-camera [2020/02/17 12:47] j0ge4622 |
searchwing-pi-camera [2020/02/17 17:35] (current) j0ge4622 |
||
|---|---|---|---|
| Line 32: | Line 32: | ||
| * Take an 8-inch JST-GH cable and remove the connector at one side. Remove 5mm of the isolation at the other. | * Take an 8-inch JST-GH cable and remove the connector at one side. Remove 5mm of the isolation at the other. | ||
| * Put this cable in the JST-GH connector at the location marked "TX". This is the UART RX port of the PixRacer. | * Put this cable in the JST-GH connector at the location marked "TX". This is the UART RX port of the PixRacer. | ||
| + | {{ :pixacer-pinlayout_telem1.jpg?direct&200 |}} | ||
| Now the power connections from the PowerModule are left. | Now the power connections from the PowerModule are left. | ||
| Line 38: | Line 39: | ||
| * Crimp the Harwin M20 connector at that side | * Crimp the Harwin M20 connector at that side | ||
| * Insert the JST-GH Cables in pin 1 and 3 of the JST-GH 4 pin power connector | * Insert the JST-GH Cables in pin 1 and 3 of the JST-GH 4 pin power connector | ||
| - | {{ ::powermodule-pinlayout_5v.jpg?direct |}} | + | {{ ::powermodule-pinlayout_5v.jpg?direct&200 |}} |
| To mark the cables use colored heating tube. | To mark the cables use colored heating tube. | ||
| {{ ::pizerow-pinlayout.png?direct |}} | {{ ::pizerow-pinlayout.png?direct |}} | ||