Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
searchwing-powermodule-in-fuselage [2020/02/14 17:10] beckmanf created |
searchwing-powermodule-in-fuselage [2020/02/23 16:27] (current) j0ge4622 |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| + | === Cable from Power module to ESC === | ||
| + | |||
| + | * Cut 210mm of the red 2.5 sqmm Muldental cable | ||
| + | * Cut 190mm of the black 2.5 sqmm Muldental cable | ||
| + | * Cut the ESC power cable to a length of 30mm from the Elko capacitor | ||
| + | * Remove 10mm of the isolation from the ESC cable and from both sides of the Muldental cable | ||
| + | * Tin all open cable ends | ||
| + | * Solder the red cable to the rectangular area in the PlusESC lane besides the MOSFET | ||
| + | * Solder the black cable to the area in the MinusESC lane close to the MOSFET | ||
| + | * Place the red ESC cable and the red Power cable from the Power module in a blue solder sleeve and hold both cables with a helping hand | ||
| + | * Heat the solder sleeve with a Steiner HL 1910E on level 5-6 until the solder ring in the solder sleeve melts | ||
| + | * Do the same for the black cable | ||
| + | |||
| + | === Cable from ESC to Motor === | ||
| + | |||
| + | * Remove 5mm of the black, blue and red ESC cable to the motor to remove the prepared tin | ||
| + | * Cut 3 x 130mm of the Muldental 2.5 sqmm cable | ||
| + | * Remove 10mm of the isolation at the solder sleeve side on each cable (ESC and Muldental) | ||
| + | * Remove 5mm of the isolation from the Muldental cable side which will be connected to the motor plugs | ||
| + | * Tin all cable ends | ||
| + | * Place the cables 10mm free ends in a blue solder sleeve and heat with HL 1910E at level 5-6 until the solder ring melts | ||
| + | * Add a motor plug to the motor connector for mechanical protection | ||
| + | * Install the motor connector with 45° in the Schraubstock such that you can see the small soldering hole | ||
| + | * Hold the cable with the 5mm removed isolation with a helping hand in the solder cup | ||
| + | * Solder with 350°C. | ||
| + | * The motor connector will be protected with a shrinking tube with hot melt. | ||
| + | * Cut 20mm of the shrinking tube and place the tube over the motor connector | ||
| + | * Shrink the shrinking tube with the Steiner HL1910E with level 3 | ||
| + | |||
| + | The cables of the Extron motor are: W, V, U (left to right, seen from back) | ||
| + | {{ ::esc_motor-top.jpg?800 |}} | ||
| + | {{ ::esc_motor-bottom.jpg?800 |}} | ||