Differences

This shows you the differences between two versions of the page.

--- searchwing-rfd868-mount [2020/02/17 12:35] – j0ge4622
+++ searchwing-rfd868-mount [2021/04/24 14:27] (current) – add note beckmanf
@@ Line 29: / Line 29: @@
 {{::sw-telem-uart.jpg?600|}}
+Pixracer pin layout: [[https://docs.px4.io/v1.9.0/assets/flight_controller/pixracer/grau_setup_pixracer_top.jpg]]
+Please note the different directions of the connector/cables in the labeling.
 Pin layout of the Pixracer
-{{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 |}}
+{{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 | Pixracer board}}
 Pin layout to the RFD868+
-{{ :pixacer-pinlayout_telem1.jpg?direct&600 |}}
+{{ :pixacer-pinlayout_telem1.jpg?direct&400 | JST-GH telemetry cable connector}}
-Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table:
+**Note the difference between the yellow cable named TX on the board and RX on the connector!!! The name RX for the yellow cable on the JST-GH cable connector refers to the RX on the RFD868 modem.** Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table:
-^ PixRacer JST-GH connector ^ RFD868+ IDC connector ^
+^ PixRacer JST-GH board ^ RFD868+ IDC connector ^
 | GND                       | GND                   |
 | RX                        | TX                    |
@@ Line 54: / Line 57: @@
 ==== Power Module to RFD868+ modem cable ====
+  * 4x 8" JST already crimped cable
+  * JST 4-pin to female connector 8-pin
+  * GND + GND, 5V + 5V (double cable)
+{{ ::powermodule-pinlayout_5v.jpg?direct |}}
-t.b.d.
+To mark the cable use colored shrink tube.