Differences

This shows you the differences between two versions of the page.

--- searchwing-wing-servo [2020/02/02 13:10]
beckmanf changed values, added closeup image
+++ searchwing-wing-servo [2020/02/03 18:52] (current)
beckmanf Shorten cable, reduce transparent shrinking tube to 20mm
@@ Line 9: / Line 9: @@
   * [[https://www.digikey.de/product-detail/de/50-00601/839-1556-ND|Tensility M5 3-pin plug]], IP67, AWG26 (0.14mm2), 2.94€
   * [[https://www.digikey.de/product-detail/de/50-00604/839-1558-ND|Tensility M5 3-pin socket]], IP67, AWG26 (0.14mm2), 3.04€
-  * [[https://m-el.eu/details/61001|Muldental Schrumpfschlauch 1,2mm black]]
+  * [[https://m-el.eu/details/61011|Muldental Schrumpfschlauch 1,6mm black]]
   * [[https://m-el.eu/details/62106 |Muldental Schrumpfschlauch 4mm/1mm transparent mit Kleber]]
@@ Line 22: / Line 22: @@
 {{:sw-servo-m5-to-pixracer.jpg?600|Solder view}}
-  * Cut 25mm of the transparent shrinking tube and put it on the cable
+  * Shorten the servo cable by 40mm
+  * Cut 20mm of the transparent shrinking tube and put it on the cable
   * Separate the yellow, red and brown cable for about 5cm
-  * Add about 5mm of the 1.2mm shrinking tube to the red and the brown cable.
+  * Add about 5mm of the small shrinking tube to the red and the brown cable.
   * Move the shrinking tubes as far as possible from the solder spot to avoid accidental shrinking
   * Remove the isolation for about 4mm and twist and tin the wires.
@@ Line 48: / Line 49: @@
 The next image shows the small shrinking tubes moved over the solder connections.
-{{:sw-m5-shrinking-tube.jpg?600|Socket with 1.2mm shrinking tubes}}
+{{:sw-m5-shrinking-tube.jpg?600|Socket with shrinking tubes}}
   * Now shrink the black shrinking tubes with a heat gun. With the Heinel EL 1910 E heat gun select temperature "3" with maximum air speed.