Placement Machine
This project focuses on the development and construction of a fully functional pick-and-place machine. This machine can autonomously populate circuit boards with SMD components down to a minimum size of SMD 0402.

Placement Machine
Degree Program
ET - Discontinued
Project Description
This project focuses on the development and construction of a fully functional pick-and-place machine. This machine can autonomously populate circuit boards with SMD components down to a minimum size of SMD 0402.
The goal of the project was to build a functional automatic placement machine. Circuit boards are to be loaded into the machine, which then populates them with components down to a minimum size of SMD 0402. The machine is controlled via the open-source software “OpenPNP.” The components are picked up automatically after they have been placed next to the circuit board.
The machine is intended to enable the cost-effective and rapid in-house production of prototypes and very small batches of circuit boards right at the university. Accordingly, the target audience consists of professors and students who would otherwise have to purchase a custom-designed circuit board or assemble one by hand for their projects.
In addition, the assembly machine was designed so that individual components can be easily replaced in the event of a defect. This also makes it simple to upgrade the components. During development, care was also taken to ensure that sufficient space is available to further expand and upgrade the machine even after the project is completed. For example, a future project could expand the machine’s component capacity. The device was thus designed with long-term development in mind.
People Involved
Student Group: Marcel Stark, Ian Reib, Mathias Mutz, Simeon Atanasov, Hannes Völk
Advisor: Prof. Dr.-Ing. Christoph Zeuke
Course
Systems Engineering 1 (IK)
Duration
Winter Semester 2024/25
Requirements
The machine was designed to meet the following requirements:
- Reliable and precise placement of individual components on a circuit board
- Integration of the open-source software “OpenPNP”
- Placement on circuit boards up to double-Europe format
(233.33 mm x 160 mm) - Component sizes starting with SMD 0402 are to be placed
In addition, a PC running a Linux distribution was set up to control the device. Any PC with the required software can be used; only sufficient USB ports for the control board and the two cameras are necessary.
To ensure error-free assembly, there are also requirements regarding the environment and the board itself that the user must adhere to:
- PC located near the placement machine
- 230V mains voltage for operating the machine
- Loaded circuit boards must already be pre-pasted
- Stable work surface; the device must not wobble or move during the placement process
Implementation
The machine was built from the ground up, which means that the first step was to design the frame and the mechanical components. A sturdy frame was constructed from aluminum profiles to ensure that the machine itself does not generate any movement during operation. The movable axes were implemented using linear guides driven by a motor via a belt. During the mechanical assembly, great care was taken to ensure precise alignment so that the machine would not jam during operation and could move to its target positions accurately.
The electrical assembly was largely carried out on a wooden board used as a base. All components—such as the power supply, the vacuum pump, and the circuit board itself—were screwed onto this board and wired. The wiring for the axes was routed using cable carriers.
The software integration phase consisted of two parts. The control board itself—which is controlled by the Marlin software—had to be configured. It had to be able to recognize, control, and read data from all components, such as motors and sensors. The second part involved integrating the controller into the OpenPNP software, which is responsible for sending control commands to the board during operation.
Once all these areas were completed, it was possible to put the placement machine into test mode and perform both calibrations and adjustments to the OpenPNP control settings.

Uses
The video demonstrates how the developed placement machine works and illustrates the automated placement process.







