Watch Projects
As part of the internship in the Technology / Embedded Systems module, students must design and build a prototype of an embedded system that incorporates sensors and actuators. This page briefly presents a few projects, some of which were developed in collaboration with projects from the Design Basics 2 and Experiences modules.

Watch Projects
Degree Program
Creative Engineering (B.A./B.Eng.)
Project Description
As part of the internship in the Technology / Embedded Systems module, students must design and build a prototype of an embedded system that incorporates sensors and actuators. This semester, everyone chose to build a clock with a temperature display. Some of the watches—which couldn’t be more different from one another—are briefly presented on this page.
Supervision in the Technology / Embedded Systems module.
Advisor: Prof. Dr.-Ing. Claudia Meitinger
Magnetic Watch
As shown in the picture, this is a clock with an analog display that is controlled by a Raspberry Pi Pico and powered by a stepper motor.
What makes this clock (inspired by the Hollow Clock) special is that the hour hand appears to be floating. This is achieved through a clever arrangement of magnets. To display the temperature, 13 LEDs are mounted on the front of the clock, showing the room temperature measured by a BME280. The clock also sends the current room temperature and humidity to an MQTT broker.
Binary Clock
This clock displays the time in binary, so the user has to add up the numbers based on the lit LEDs to read the correct time—a nerdy yet educational experience!
The Binaryclock also measures the current room temperature and displays it on a color-coded scale using a servo motor. Blue stands for “cool,” green for “optimal,” and red for “too warm.”
At the heart of the project are a Raspberry Pi Pico, LEDs, and a BME280 temperature sensor. The transparent Plexiglas case keeps the technology visible, making the clock’s inner workings a real eye-catcher.
Mechanical watch
This mechanical clock displays the current local time as well as the room temperature. The wooden dial gives it a classic look, while the 3D-printed frame provides a modern and sturdy casing. An LED ring indicates the minutes and changes color depending on the room temperature: red for temperatures above 26°C, blue for temperatures below 20°C, and purple for temperatures in between.
After being turned on, the clock automatically syncs the time via Wi-Fi. The hour hand then uses an LDR sensor to find the 12 o’clock position and moves to the current hour. A DHT11 sensor measures the room temperature, which is then displayed via the LEDs. This combination of software, hardware, and design reflects the content of the “Embedded Systems” module and the “Creative Engineering” degree program in which the project was developed.
A stepper motor drives a cassette via a belt, on which a chain is mounted. Numbers from 1 to 12 are attached to the chain. This allows the time to be read with an accuracy of approximately 15 minutes. Since the stepper motor is weak, the heavy cassette must be well-supported so that it can still be driven.
A mounting system using four skateboard ball bearings ensures the cassette rotates smoothly. The cassette is held in place on the gear wheel by five magnets. The temperature is measured using a temperature sensor (DHT11) and displayed on two 7-segment displays.
The video demonstrates how the mechanical clock works; it uses a stepper motor to display the time and shows the measured room temperature via LEDs or 7-segment displays.

















